Instrument Cluster Replacement
Preliminary Procedure
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m (22 lb in)
Procedure
Radio Control Module Replacement
Preliminary Procedures
Remove instrument panel center upper molding. Refer to Instrument Panel Center Upper Molding Replacement
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m(22 lb in)
Procedure
Disconnect electrical components.
Radio Replacement
Preliminary Procedure
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m(22 lb in)
Procedure
Radiator Support Bracket Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
Caution: Refer to Fastener Caution in the Preface section.
Tighten 22 N·m (17 lb ft)
Procedure
Pull the radiator forward until the bracket is reachable.
Installation Procedure
Install NEW stabilizer shaft insulators (1) to stabilizer shaft (2) so
that the slit in the insulator is facing the rear of the vehicle.
Install the insulator c 2. lamp to the insulator:
2.1. Position the clamp (2) over on the insulator.
2.2. Use two M8 bolts (1, 3) with 40 ...
Turn Signal Switch Replacement
Preliminary Procedure
Remove the steering column upper trim cover. Refer to Steering Column
Upper Trim Cover Replacement.
Remove the steering column lower trim cover. Refer to Steering Column
Lower Trim Cover Replacement.
Turn Signal Switch
Procedure
Disconnect any elec ...
Radiator Grille Reinforcement Support Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
Radiator Grille Reinforcement Support Bolt (Qty: 4)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
10 N·m (89 lb in).
Radiator Grille Reinforcement Support Retainer ...