Chevrolet Cruze Repair Manual: Aluminum Wheel Porosity Repair

Chevrolet Cruze Repair Manual / Suspension / Tires and Wheels / Aluminum Wheel Porosity Repair

Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
Inflate the tire to the manufactures specified pressure as stated on the tire.
Submerge the tire/wheel into a water bath in order to locate the leak.
Inscribe a mark on the wheel in order to indicate the leak areas.
Inscribe a mark on the tire at the valve stem in order to indicate the orientation of the tire to the wheel.
Remove the tire from the wheel. Refer to Tire Dismounting and Mounting.

Note: Do not damage the exterior surface of the wheel.

Use number 80 grit sandpaper to scuff the inside of the rim surface at the leak area.
Use general purpose cleaner to clean the leak area.
Apply 3 mm (0.12 in) thick layer of adhesive/sealant to the leak area. Refer to Adhesives, Fluids, Lubricants, and Sealers.
Allow for the adhesive/sealant to dry.
Align the inscribed mark on the tire with the valve stem on the wheel.
Install the tire to the wheel. Refer to Tire Dismounting and Mounting.
Pressurize the tire to 276 kPa (40 psi).
Submerge the tire/wheel into a water bath in order ensure the leak is sealed.
Inflate the tire to the specified pressure as stated on the tire placard.
Balance the tire and wheel. Refer to Tire and Wheel Assembly Balancing - Off Vehicle.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.

Aluminum Wheel Refinishing

Finish Damage Evaluation Procedure Note: If the wheels are chrome-plated, do not re-plate or refinish the wheels. If the wheels are polished aluminum, do not refinish the wheels in the de ...

Other materials:

Test Probe Caution
Caution: Do not insert test equipment probes (DMM etc.) into any connector or fuse block terminal. The diameter of the test probes will deform most terminals. A deformed terminal will cause a poor connection, which will result in a system failure. Always use the EL-35616 GM-Approved Terminal T ...

Floor Carpet Drying
If the carpet or the pad or insulator is wet, use the following criteria for drying or for replacing the components: For a 1-piece carpet assembly bonded to a cotton or a fiber padding, replace the entire assembly For a 2-piece carpet assembly with a cotton or a fiber padding, replace ...

Tyre Repair
Warning: Tire changing can be dangerous and should be done by trained professionals using proper tools and procedures. Always read and understand any manufacturer's warnings contained in their customers literature or molded into the tire sidewall. Serious eye and ear injury may result from no ...