Chevrolet Cruze Infotainment System: Bluetooth Audio
If equipped, music may be played from a paired Bluetooth device.
To play music through a Bluetooth device: 1. Power on the device, pair, and connect the device.
2. Music can be launched by doing one of the following:
• Press the Bluetooth Audio screen button on the Home Page.
• Press SOURCE or SRCE until Bluetooth Audio is selected.
• Press the SRC button on the steering wheel controls until Bluetooth Audio is selected.
• Use voice recognition.
The music can be controlled by either the infotainment controls or the controls on the device.
When a phone is connected to the system through Bluetooth Audio the phone notifications and sounds may not be heard on the phone until Bluetooth is disconnected.
Notification features may vary based on the phone. Check the phone manufacturer’s information for notification support.
Bluetooth Audio Menu
Press the Menu screen button and the following may display: Shuffle
: Press the MENU/SEL or MENU knob to turn shuffle on or off.
Not all devices support the shuffle feature.
When selecting Bluetooth audio, the Bluetooth device internal music player may not open depending on the status of the device. All devices launch and play back audio differently. Make sure the correct audio source is playing on the device for Bluetooth audio playback on the radio. When the vehicle is not moving, use the device to begin playback.
When selecting Bluetooth audio as a source, the radio may source to the Bluetooth
Audio Paused screen with no audio playing. Press play on the device or push
to begin playback. This may happen
depending on how the device communicates over Bluetooth.
Some phones support sending Bluetooth music information to display on the radio. When the radio receives this information, it will check to see if any album art is available and display it.
When playing music on the radio from a Bluetooth device, make sure the Bluetooth device is unlocked and the intended music application is showing on the home screen.
For iPhone/iPod touch and iPad devices, Bluetooth Audio will not work if the device is connected through the USB and Bluetooth at the same time.
Auxiliary Devices
This vehicle has an auxiliary input jack in the center console. Possible auxiliary
audio sources include:
• Laptop computer
• MP3 player
• Tape player
This jack is not an audio output.
Do not p ...
Navigation
...
Other materials:
Installation Procedure
Cut the rocker outer panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioning
joint.
Create 50 mm (2 in) backing plates from the unused portion of the
...
Installation Procedure
Align the rocker inner panel.
Drill 8 mm (5/16 in) for plug welding along the edges of the quarter
outer panel as noted from the original panel.
Clean and prepare the attaching surfaces for welding.
Position the rocker inner panel on the vehicle.
Verify the fit of ...
Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located in the trunk, under the load floor,
behind an access panel.
To remove the kit:
1. Open the trunk.
2. Turn the left knob counterclockwise and the right knob clockwise, 90 degrees,
at the same time. Then pull the access panel rearward and up to r ...
