Rear Compartment Lid Emblem/Nameplate Replacement (Bowtie)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the
Preface section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the drivetrain
and front suspension frame front support as noted from the
original panel.
Clean and prepare the attaching surfaces for welding.
Position the drivetrain and front suspension frame front suppor ...
Outback Gets Turbo Boost and XT Badge Returns in Australia
Subaru Australia is giving the 2023 Outback a shot of adrenaline with the introduction of the turbocharged Outback XT. This new variant injects a much-needed dose of power into the popular wagon, addressing the loss of the 3.6-liter engine from the previous generation.
Under the hood of the car ...