Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body hardware and trim

Chevrolet Cruze Repair Manual / Body hardware and trim

Stationary Window Waterleak Repair
Note: If any water enters the vehicle interior up to the level of the carpet or higher and soaks the carpet, the sensing and diagnostic module (SDM) and the SDM harness connector may need to be rep ...

Exterior Trim
...

Other materials:

Pretensioner Handling and Scrapping
Special Tools EL-38826 SIR Deployment Harness EL-39401-B SIR Deployment Fixture For equivalent regional tools, refer to Special Tools. Warning: When you are carrying an undeployed seat belt pretensioner: Do not carry the seat belt pretensioner by the wires or connector on the preten ...

Front Side Door Wiring Harness Replacement
Preliminary Procedure Remove the front side door inner panel trim. Refer to Front Side Door Trim Replacement. Front Side Door Wiring Harness Warning: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before ...

Rear Compartment Lid Emblem/Nameplate Replacement (Bowtie)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

© 2011-2026 Copyright www.ccruze.com