Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body Hinge Pillar Lower Reinforcement Replacement (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Body Hinge Pillar Lower Reinforcement Replacement (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Cut the front hinge pillar body in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal th ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR   Disabling and Enabling. Disconnect the negative battery cable. Refer to ...

Ultra High Strength Dual Phase Steel
This information provides repair recommendations and general guidelines for steel classified as Ultra High Strength Dual Phase Steel (Dual Phase Steel with a tensile strength greater than 800 MPa), also known as DPX. General Motors recommends the following when repairing or replacing this type ...

Rear Compartment Lid Adjustment
Rear Compartment Lid Caution: Refer to Fastener Caution in the Preface section. Procedure Loosen the rear compartment lid hinge bolt (Qty: 4) to   adjust the rear compartment lid. Adjust the rear compartment lid in order to obtain an even gap between the rear compartment ...

© 2011-2026 Copyright www.ccruze.com