Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body Rear End Panel Replacement (MIG-Brazing)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Body Rear End Panel Replacement (MIG-Brazing)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Drill 8 mm (5/16 in) for plug welding along the edges of th ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Other materials:

Installation Procedure
Prepare all mating surfaces as necessary. Align the front hinge pillar body reinforcement. Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing in locations where you can not apply   a resistance spot welder. Clean and prepare the attaching surfaces for spot welding a ...

Safety Belt Use During Pregnancy
Safety belts work for everyone, including pregnant women. Like all occupants, they are more likely to be seriously injured if they do not wear safety belts. A pregnant woman should wear a lap-shoulder belt, and the lap portion should be worn as low as possible, below the rounding, throughout ...

Rear Compartment Lid Emblem/Nameplate Replacement (Cruze - Left Side)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

© 2011-2026 Copyright www.ccruze.com