Chevrolet Cruze Repair Manual: Bolted Exterior Body Panels and Closures
Specifications
- Front End Upper Tie Bar Replacement
- Front Fender Front Lower Bracket Replacement
- Hood Primary Latch Release Cable Replacement
- Rear Side Door Check Replacement
- Front Side Door Adjustment
- Front Side Door Replacement
- Rear Side Door Adjustment
- Rear Side Door Replacement
- Front Fender Replacement
- Front Side Door Wiring Harness Replacement
- Rear Side Door Wiring Harness Replacement
- Hood Primary Latch Release Cable Handle Replacement
- Front Side Door Upper Hinge and Lower Hinge Replacement
- Rear Side Door Upper Hinge and Lower Hinge Replacement
- Hood Adjustment
- Hood Replacement
- Hood Primary and Secondary Latch Replacement
- Rear Compartment Lid Adjustment
- Rear Compartment Lid Replacement
- Front Side Door Check Replacement
- Fuel Tank Filler Pipe Housing Replacement
- Hood Hold-Open Rod Replacement
- Rear Compartment Lid Hinge Torque Rod Replacement
- Radiator Grille Reinforcement Support Replacement
- Front Side Door Weatherstrip Replacement - Door Side
- Front Side Door Weatherstrip Replacement - Body Side
- Rear Compartment Lid Weatherstrip Replacement
- Rear Side Door Weatherstrip Replacement - Door Side
- Rear Side Door Weatherstrip Replacement - Body Side
Body repair
...
Front End Upper Tie Bar Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia
Replacement
Remove the radiator support bracket. Refer to Radiator Support Bracket
Replacement
...
Other materials:
Front Side Door Wiring Harness Replacement
Preliminary Procedure
Remove the front side door inner panel trim. Refer to Front Side Door Trim
Replacement.
Front Side Door Wiring Harness
Warning: Unless directed otherwise, the ignition and start switch must be
in the OFF or LOCK position, and all electrical
loads must be OFF before ...
Windshield Garnish Molding Replacement
Preliminary Procedure
Disable the SIR system. Refer to SIR Disabling and Enabling.
Windshield Garnish Molding Assembly
Procedure
Loosen tether clip and steel clips.
Disconnect electrical connector.
The tether clip at the upper portion of the garnish molding MUST be
repla ...
Installation Procedure
Remove the front wheelhouse rear panel brace (1) from service panel.
Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing along the edges
of the front wheelhouse (1).
Clean and prepare the attaching surfaces for brazing.
Note: In MIG-brazing areas 50 mm (2 in) must b ...
