Chevrolet Cruze Owners Manual: California Fuel Requirements
If the vehicle is certified to meet California Emissions Standards, it is designed to operate on fuels that meet California specifications. See the underhood emission control label. If this fuel is not available in states adopting California Emissions Standards, the vehicle will operate satisfactorily on fuels meeting federal specifications, but emission control system performance might be affected. The malfunction indicator lamp could turn on and the vehicle might fail a smog‐check test.
If this occurs, return to your authorized dealer for diagnosis.
If it is determined that the condition is caused by the type of fuel used, repairs might not be covered by the vehicle warranty.
Gasoline Specifications
At a minimum, gasoline should meet ASTM specification D 4814. Some gasolines
contain an octane-enhancing additive called methylcyclopentadienyl manganese tricarbonyl
(MMT). We recommend against th ...
Fuels in Foreign Countries
If planning to drive in countries outside the U.S. or Canada, the proper fuel
might be hard to find.
Check regional auto club or fuel retail brand websites for availability in the
country where d ...
Other materials:
Basecoat/Clearcoat Paint Systems
Warning: Exposure to isocyanates during paint preparation and
application processes can cause severe breathing problems. Read and
follow all of the instructions from the manufacturers of painting materials,
equipment, and protective gear.
All paint finish repairs of rigid exterior surfaces mus ...
Front Side Door Wiring Harness Replacement
Preliminary Procedure
Remove the front side door inner panel trim. Refer to Front Side Door Trim
Replacement.
Front Side Door Wiring Harness
Warning: Unless directed otherwise, the ignition and start switch must be
in the OFF or LOCK position, and all electrical
loads must be OFF before ...
Remote Vehicle Start
For vehicles with this feature, the engine can be started from outside the vehicle.
Starting the Vehicle
1. Aim the RKE transmitter at the vehicle.
2. Press and release .
3. Immediately after completing Step 2, press and hold
for at least two seconds or until the
turn signal lamps flash.
Wh ...
