Chevrolet Cruze Owners Manual: Cruise Control Messages
APPLY BRAKE BEFORE CRUISE
If this message displays when attempting to activate cruise control, apply the brake pedal and try again.
CRUISE SET TO XXX
This message displays when the cruise control is set and shows the speed it was set to.
Compass Messages
CAL
This message is displayed when the compass needs to be calibrated.
– –
Two dashes will be displayed if the compass needs service. See your dealer for
service. ...
Door Ajar Messages
DOOR(S) OPEN
A vehicle symbol will be displayed on the DIC showing which door is open along
with this message.
Close the door completely.
HOOD OPEN
This message will display when the hood is ope ...
Other materials:
Installation Procedure
Note: If the location of the original plug weld holes can not be
determined, space the plug weld holes every 40 mm (1½ in).
Drill 8 mm (5/16 in) for plug welding along the edges of the rear floor
panel filler as noted from the original
panel.
Clean and prepare the atta ...
Installation Procedure
Align the rear compartment floor panel.
Drill 8 mm (5/16 in) for plug welding along the edges of the rear compartment
floor panel as noted from the original panel.
Clean and prepare the attaching surfaces for
welding.
Position the rear compartment floor panel on the vehicle.
V ...
SIR Identification Views
The SIR Identification Views shown below illustrate the approximate location
of all SIR components available for the vehicle. This will assist
in determining the appropriate SIR Disabling and Enabling for a given service
procedure, refer to SIR Disabling and Enabling.
Front End Sensor-- ...
