Customer Satisfaction ProcedureInstallation Procedure
Install NEW stabilizer shaft insulators (1) to stabilizer shaft (2) so
that the slit in the insulator is facing the rear of the vehicle.
Install the insulator c 2. lamp to the insulator:
2.1. Position the clamp (2) over on the insulator.
2.2. Use two M8 bolts (1, 3) with 40 ...
Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the service
panel as noted from the original panel.
Clean and prepare the attaching surfaces for welding.
Apply one-part windshield urethane adhesive as noted
from the original panel.
Position the roof ...
Hood Replacement
Warning: When a hood hold open device is being removed or installed,
provide alternate support to avoid the possibility of
damage to the vehicle or personal injury.
Preliminary Procedure
Remove the windshield washer nozzle hose. Refer to Windshield Washer Nozzle
Hose Replacement.
Hood ...