Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Engine Oil Messages

CHANGE ENGINE OIL SOON

This message displays when the engine oil needs to be changed.

When you change the engine oil, be sure to reset the Oil Life System.

OIL PRESSURE LOW — STOP ENGINE

This message displays if low oil pressure levels occur. Stop the vehicle as soon as safely possible and do not operate it until the cause of the low oil pressure has been corrected. Check the oil as soon as possible and have the vehicle serviced by your dealer.

Engine Cooling System Messages
A/C OFF DUE TO HIGH ENGINE TEMP This message displays when the engine coolant becomes hotter than the normal operating temperature. To avoid added strain on a hot engine, the air conditioning comp ...

Engine Power Messages
ENGINE POWER IS REDUCED This message displays when the vehicle's engine power is reduced. Reduced engine power can affect the vehicle's ability to accelerate. If this message is on, but the ...

Other materials:

Installation Procedure
Cut the front compartment front rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused porti ...

Antilock Brake System (ABS) Warning Light
The Antilock Brake System (ABS) light comes on briefly when the engine is started. If the light does not come on, have it fixed so it will be ready to warn if there is a problem. If the ABS light comes on and stays on while driving, stop as soon as possible and turn the ignition off. Start ...

Front Wheel Drive Shaft Replacement - Left Side
Special Tools CH-313 Slide Hammer CH-6003 Axle Shaft Remover CH-46376 Holding Wrench CH-49400 Hub Spindle Remover DT-6332 Seal Protector EN-956-1 Extension For equivalent regional tools, refer to Special Tools. Removal Procedure Warning: To prevent personal injury and/or component ...

© 2011-2026 Copyright www.ccruze.com