Chevrolet Cruze Repair Manual: Exhaust Flexible Pipe Replacement (1.6L LXT)
Removal Procedure
Warning: Refer to Hot Exhaust System Warning in the Preface section.
Warning: Refer to Protective Goggles and Glove Warning in the Preface section.
- Open the hood.
- Raise the vehicle by its full height. Refer to Lifting and Jacking the Vehicle.
- Remove the heated oxygen sensor (1).
- Remove the 4 exhaust flexible pipe bracket bolts (5).
- Remove the 3 exhaust flexible pipe nuts (8).
- Remove the 2 exhaust flexible pipe nuts (3).
- Remove the exhaust flexible pipe (7).
- Remove the gasket (9).
- Remove the gasket (4).
Installation Procedure
- Install a NEW gasket (4).
- Install a NEW gasket (9).
- Install the exhaust flexible pipe (7).
Caution: Refer to Fastener Caution in the Preface section.
- Install 2 NEW exhaust flexible pipe nuts (3) and tighten to 20 N·m(15 lb ft).
- Install 3 NEW exhaust flexible pipe nuts (8) and tighten to 20 N·m(15 lb ft).
- Install the 4 exhaust flexible pipe bracket bolts (5) and tighten to 40 N·m(30 lb ft).
- Install the heated oxygen sensor (1) and tighten to 40 N·m(30 lb ft).
- Lower the vehicle by its full height.
- Close the hood.
Battery Negative Cable Disconnection and Reconnection
Removal Procedure
Turn on the radio and record all of the customer radio station presets.
Ensure that all lamps and accessories are turned off.
Turn the ignition OFF and remove the ignition ke ...
Power Steering Pump Belt Replacement
Special Tools
CH 49800 Installer Power Steering Pump Belt
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Caution: Do not use belt dressing on the drive belt. Belt dressin ...
Other materials:
Steering Wheel Inflatable Restraint Module Replacement
Removal Procedure
Warning: When carrying a live inflator module, make sure the bag opening
is pointed away from you. This minimizes the chance of injury
in the case of an accidental deployment. Never carry the inflator module by the
wires. Never carry the inflator module by the connector on
t ...
Seat Belt Latch Stop Installation
Preliminary Procedure
Locate the hole in the seat belt webbing where the original seat belt
stop button was located.
If the original hole in the seat belt webbing is not visible, perform
the following:
If either the right or left stop button is missing use the opposing seat
...
Rear Compartment Lid Emblem/Nameplate Replacement (CDX)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface
section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
