Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Exit Lighting

The headlamps, taillamps, parking lamps, back-up lamps, and license plate lamps come on at night, or in areas with limited lighting, when the key is removed from the ignition.

The dome lamps also come on when the key is removed from the ignition. The exterior lights and dome lamps remain on after the door is closed for a set amount of time, then automatically turn off.

For vehicles with keyless access, the exterior lamps and dome lamps automatically turn on when a door is opened after the ignition is turned off.

The exterior lamps turn off immediately by turning the exterior lamps control off.

This feature can be changed.

Entry Lighting
The headlamps, parking lamps, taillamps, back-up lamps, and most of the interior lamps turn on briefly when is pressed on the Remote Keyless Entry (RKE) transmitter. After about 30 seconds the e ...

Battery Power Protection
The battery saver feature is designed to protect the vehicle's battery. If some interior lamps are left on and the ignition is turned off, the battery rundown protection system automatically tu ...

Other materials:

StabiliTrak® OFF Light
This light comes on briefly while starting the engine. If it does not, have the vehicle serviced by your dealer. This light comes on when the StabiliTrak system is turned off. If StabiliTrak is off, the Traction Control System (TCS) is also off. If the TCS is off, the system does not assist i ...

High Strength Low Alloy Steel
This information provides repair recommendations and general guidelines for steel classified as High Strength Low Alloy Steel, also known as HSLA. This type of steel normally has a tensile strength range from 300-700 MPa. General Motors recommends the following when repairing or replacing th ...

Installation Procedure
Cut the rocker outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create 50 mm (2 in) backing plates from the unused portion of the ...

© 2011-2026 Copyright www.ccruze.com