Chevrolet Cruze Owners Manual: Exterior Lighting
The exterior lamp control is to the left of the steering column on the instrument panel.
: Briefly turn to this position
to turn the automatic lamp control off or on again.
AUTO: Turns the headlamps on automatically at normal brightness, together with the parking lamps, taillamps, license plate lamps, sidemarker lamps, and instrument panel lights.
: Turns on the parking lamps, taillamps,
license plate lamps, sidemarker lamps, and instrument panel lights.
: Turns on the headlamps, parking
lamps, taillamps, license plate lamps, sidemarker lamps, and instrument panel lights.
A warning chime sounds if the driver door is opened when the ignition switch is
off and the headlamps are on.
: For vehicles with fog lamps, press
to turn the lamps on or off.
See:
• Exterior Lamp Controls
• Daytime Running Lamps (DRL)
• Front Fog Lamps
Interior Lighting
Dome Lamps
The dome lamp controls are located in the headliner.
: Press to turn the lamps off, even
when a door is open.
: Press to turn the lamps on automatically
when a door is opened.
: ...
Windshield Wiper/Washer
The windshield wiper/washer lever is on the right side of the steering column.
With the ignition in ACC/ ACCESSORY or ON/RUN, move the windshield wiper lever to
select the wiper speed.
HI: Use ...
Other materials:
Installation Procedure
Cut the front compartment upper side rail in corresponding locations to
fit the remaining original panel. The sectioning joint should
be trimmed to allow a gap of one-and-one-half-times the metal thickness at
the sectioning joint.
Create a 50 mm (2 in) backing plate from the unused ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR
Disabling and Enabling.
Disconnect the negative battery cable. Refer to ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Dis ...
