Chevrolet Cruze Repair Manual: Exterior Trim
- Specifications
- Front Fender Emblem/Nameplate Replacement (1.8L 2H0 or 2.0L Diesel)
- Front Fog Lamp Bezel Replacement
- Rear Compartment Lid Emblem/Nameplate Replacement (Bowtie)
- Rear Compartment Lid Emblem/Nameplate Replacement (Chevrolet)
- Rear Compartment Lid Emblem/Nameplate Replacement (Cruze - Right Side)
- Rear Compartment Lid Emblem/Nameplate Replacement (CDX)
- Rear Compartment Lid Emblem/Nameplate Replacement (Cruze - Left Side)
- Rear Compartment Lid Emblem/Nameplate Replacement (Rear Emblem)
- Rear Compartment Lid Emblem/Nameplate Replacement (LT or LTZ)
- Rear Compartment Lid Emblem/Nameplate Replacement (VCDi)
- Rear Compartment Lid Emblem/Nameplate Replacement (VCDi AT)
- Water Management Description and Operation
Specifications
Front Door (Diesel)
65 mm
83 mm
Front Door (Diesel)
60 mm
87 mm
Rear Compartment Lid (Diesel)
122 mm
32 mm
Rear Compartment Lid (Ecoline)
162 mm
32 ...
Other materials:
Driver or Passenger Seat Back Cushion Cover and Pad Replacement
Removal Procedure
Warning: Refer to SIR Warning in the Preface section.
Warning: Replace the passenger presence system as a complete assembly to prevent
possible injury to the occupant. The bladder, the
pressure sensor, the seat cushion, and the control module are assembled and
calibrated a ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in
the Preface section.
Disable the SIR System. Refer to SIR Disabling
and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove all related panels and co ...
Installation Procedure
Cut the rear side rail in corresponding locations to fit the remaining
original panel. The sectioning joint should be trimmed to allow a
gap of one-and-one-half-times the metal thickness at the sectioning joint.
Create a 50 mm (2 in) backing plate from the unused portion of the
serv ...
