Chevrolet Cruze Repair Manual: Exterior Windnoise
Warning: Refer to Assistant Driving Warning in the Preface section.
Exterior windnoise is louder when the vehicle is driven with one or more windows down. Exterior windnoise occurs when air passes over the body panels, the seams, or the openings. Use the following items during the test drive in order to aid in the detection of leaks:
- Mechanic's stethoscope or heater hose
- Masking tape-51 mm (2 in) width
- Strip caulk
- A water soluble marking pencil
- While driving, determine the location of the exterior windnoise by lowering one window at a time. If the location corresponds with the condition in step 2, pull over and make a temporary repair with 51 mm (2 in) wide masking tape.
- Tape over the gaps and the moldings one at a time. Test between each taping. Taping over the gaps and moldings will correct the condition.
- Temporarily repair the condition with masking tape. Adjust the tape when needed.
- Continue testing in order to determine if the noise has been eliminated or other leak areas exist.
- When all the reported leak conditions are located, make permanent repairs using the proper alignment techniques and the sealing materials.
Tracing Powder or Chalk Test
Clean the weatherstrips and the contact surfaces with cleaning solvent.
Apply powder or chalk in an unbroken line to the contact surface of the
weatherstrip surrounding the perimeter of the sus ...
Interior Windnoise
Warning: Refer to Assistant Driving Warning in the Preface section.
Interior windnoise is not heard when the window is lowered. Interior
windnoise is caused by the air leaving the inside of the veh ...
Other materials:
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR
Disabling and Enabling.
Disconnect the negative battery cable. Refer to ...
Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the front
wheelhouse panel rear reinforcement as noted from the original
panel.
Drill 8 mm (5/16 in) for plug welding where front wheelhouse front panel
and front wheelhouse panel rear reinforcement overlap ...
Installation Procedure
Install the following components on the drivetrain and front suspension
frame if removed:
The radiator support brackets.
The stabilizer shaft--Refer to Stabilizer Shaft Replacement.
The lower control arms--Refer to Lower Control Arm Replacement.
The steering gear--Refer to Steering ...
