Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Floor Air Outlet Replacement

Chevrolet Cruze Repair Manual / HVAC System / Floor Air Outlet Replacement

Removal Procedure

  1. Remove the instrument panel assembly. Refer to Instrument Panel  Assembly Replacement.

  1. Remove the instrument panel wiring harness (2) from the instrument panel tie bar (1).

Disconnect the electrical connectors.

  1. Remove the instrument panel tie bar (2).
  1. Remove the heater wiring harness.

  1. Remove the floor air outlet (2).

Remove the 6 floor air outlet bolts (1).

Installation Procedure

Caution: Refer to Fastener Caution in the Preface section.

Caution: Refer to Fastener Caution in the Preface section.

  1. Install  the floor air outlet (2).

Install the 6 floor air outlet bolts (1) and tighten to 2.5 Nm (23 lb in).

  1. Install the heater wiring harness.

  1. Install the instrument panel tie bar (2).

  1. Attach the instrument panel wiring harness (2) to the instrument panel tie bar (1).

Connect the electrical connectors.

  1. Install the instrument panel assembly. Refer to Instrument Panel Assembly Replacement.
Instrument Panel Outer Air Outlet Replacement - Left Side
Preliminary Procedure Remove instrument panel lower trim pad cover - left side. Refer to Instrument Panel Lower Trim  Pad Cover Replacement. Remove instrument panel cluster trim plat ...

Instrument Panel Outer Air Outlet Duct Replacement
Preliminary Procedure Remove instrument panel assembly. Refer to Instrument Panel Assembly Replacement. Instrument Panel Outer Air Outlet Duct Screw (Qty: 7) Caution: Refer to Fastener Cautio ...

Other materials:

Test Probe Caution
Caution: Do not insert test equipment probes (DMM etc.) into any connector or fuse block terminal. The diameter of the test probes will deform most terminals. A deformed terminal will cause a poor connection, which will result in a system failure. Always use the EL-35616 GM-Approved Terminal T ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR   Disabling and Enabling. Disconnect the negative battery cable. Refer to ...

Deployment Outside Vehicle for Seat Belt Pretensioners
Deploy the seat belt pretensioners outside of the vehicle when the vehicle will be returned to service. Situations that require deployment outside of the vehicle include the following: Using the SIR diagnostics, you determine that the seat belt pretensioner is malfunctioning. The pretens ...

2011-2022 Copyright www.ccruze.com