Chevrolet Cruze Repair Manual: Front End Upper Tie Bar Replacement
Preliminary Procedure
- Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement
- Remove the radiator support bracket. Refer to Radiator Support Bracket Replacement
- Remove the radiator grille reinforcement support. Refer to Radiator Grille Reinforcement Support Replacement
- Remove the hood primary and secondary latch. Refer to Hood Primary and Secondary Latch Replacement
- Headlamp and Front Bumper Fascia Mount Panel Bolt (Qty: 4)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 22 N·m (17 lb ft)
- Front End Upper Tie Bar
Bolted Exterior Body Panels and Closures
Specifications
...
Front Fender Front Lower Bracket Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia
Replacement.
Remove the headlamp. Refer to Headlamp Replacement
Remove the front fender. R ...
Other materials:
Infotainment
The names, logos, emblems, slogans, vehicle model names, and vehicle body designs
appearing in this manual including, but not limited to, GM, the GM logo, CHEVROLET,
the CHEVROLET Emblem, CRUZE, and the CRUZE logo are trademarks and/or service marks
of General Motors LLC, its subsidiaries, a ...
Rear Seats
Either side of the rear seatback can be folded.
To fold the rear seatbacks:
1. Place the front seatbacks in the upright position.
Notice: Folding a rear seat with the safety belts still fastened may
cause damage to the seat or the safety belts. Always unbuckle the safety belts and
return them ...
Rear Side Door Weatherstrip Replacement - Body Side
Rear Side Door Weatherstrip - Body Side
Procedure
Start at the front upper corner of the door opening and pull the
weatherstrip away from the door opening flange.
Position the weatherstrip in the upper corner of the center pillar.
Working downward along the front edge, in ...
