Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front End Upper Tie Bar Replacement (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Front End Upper Tie Bar Replacement (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Cut the front end upper tie bar in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal th ...

Removal Procedure
Disable the SIR System. Refer to SIR Disabling and Enabling. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove all related panels an ...

Other materials:

Installation Procedure
Cut the roof front header panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion of ...

Auxiliary Devices
This vehicle has an auxiliary input jack in the center console. Possible auxiliary audio sources include: • Laptop computer • MP3 player • Tape player This jack is not an audio output. Do not plug headphones into the auxiliary input jack. Set up any auxiliary device while the vehicle is in ...

Installation Procedure
Install NEW stabilizer shaft insulators (1) to stabilizer shaft (2) so that the slit in the insulator is facing the rear of the vehicle. Install the insulator c 2. lamp to the insulator: 2.1. Position the clamp (2) over on the insulator. 2.2. Use two M8 bolts (1, 3) with 40 ...

© 2011-2026 Copyright www.ccruze.com