Chevrolet Cruze Repair Manual: Front End Upper Tie Bar Support Sectioning (MIG Brazing)

Front End Upper Tie Bar Support Sectioning (MAG Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning in t ...

Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Rear Compartment Lid Emblem/Nameplate Replacement (LT or LTZ)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

Installation Procedure
Cut the front compartment upper side rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused ...

Front Side Door Weatherstrip Replacement - Door Side
Front Side Door Check Bolt Caution: Refer to Fastener Caution in the Preface section. Tighten 25 N·m (19 lb ft) Front Side Door Weatherstrip - Door Side Procedure Unclip weatherstrip 1. from front side door. When removing protective liners from adhesive tape, be careful no ...