Preliminary Procedure
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m (23 lb in)
Procedure
Front Bumper Fascia Front Tow Eye Access Hole Cover Replacement
Front Side Door Window Frame Rear Cover Replacement
Caution: Refer to Fastener Caution in the Preface section.
Tip
Pull the window weatherstrip aside.
Tighten
2 N·m (18 lb in)
Rear Side Door Window Frame Front Cover Replacement
Caution: Refer to Fastener Caution in the Preface section.
Tip
Pull the window weatherstrip aside.
Tighten 2 N·m (18 lb in)
Radiator Grille Emblem/Nameplate Replacement (Chevrolet)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m(22 lb in)
Rear Compartment Lid Emblem/Nameplate Replacement (Chevrolet)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface
section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
Engine Oil Life System
When to Change Engine Oil
This vehicle has a computer system that indicates when to change the engine oil and filter. This is based on a combination of factors which include engine revolutions, engine temperature, and miles driven.
Based on driving conditions, the mileage at which an oil ...
Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges
of the tail lamp pocket as noted f rom the
original panel.
Note:
Clean and prepare the attaching surfaces for brazing.
Position the tail lamp pocket on the vehicle.
Verify the fit of the ta ...