Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front Side Door Wiring Harness Replacement

Preliminary Procedure

Preliminary Procedure

Remove the front side door inner panel trim. Refer to Front Side Door Trim Replacement.

Front Side Door Wiring Harness

Warning: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

For Vehicles equipped with OnStar® (UE1) with Back Up Battery: The Back Up Battery is a redundant power supply to allow limited OnStar® functionality in the event of a main vehicle battery power disruption to the VCIM (OnStar®module). Do not disconnect the main vehicle battery or remove the OnStar® fuse with the ignition key in any position other than OFF. Retained accessory power (RAP) should be allowed to time out or be disabled (simply opening the driver door should disable RAP) before disconnecting power. Disconnecting power to the OnStar® module in any way while the ignition is On or with RAP activated may cause activation of the OnStar® Back-Up Battery (BUB) system and will discharge and permanently damage the back-up battery. Once the Back-Up Battery is activated it will stay on until it has completely discharged. The BUB is not rechargeable and once activated the BUB must be replaced.

Procedure

  1. Disconnect the battery.
  2. Remove the water deflector.
  3. Disconnect electrical connectors as needed.

Rear Compartment Lid Wiring Harness Replacement

Preliminary Procedure

Preliminary Procedure

Remove the rear compartment lid inner panel trim. Refer to Rear Compartment Lid Inner Panel Trim Replacement.

  1. Rear Compartment Lid Wiring Harness Plug

Procedure

  1. Disconnect the battery.
  2. Release the locking device to disconnect the wiring harness plug.
  1. Rear Compartment Lid Wiring Harness
Front Fender Replacement
Preliminary Procedure Remove the front bumper fascia. Refer to Front  Bumper Fascia Replacement Remove front bumper fascia guide. Refer to Front Bumper Fascia Replacement Remove ...

Rear Side Door Wiring Harness Replacement
Preliminary Procedure Remove the rear side door inner panel trim. Refer to Rear Side Door Trim Replacement. Rear Side Door Wiring Harness Warning: Unless directed otherwise, the ignition ...

Other materials:

Airbag Readiness Light
This light shows if there is an electrical problem with the airbag system. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules, the wiring, and the crash sensing and diagnostic module. The airbag readiness light comes on for several ...

Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the brake rotor. Refer to Front Brake Rotor Replacement. Remove the wheel speed sensor screw (2). Remove the wheel speed sensor (1) from the steering knuckle. Remove the wheel drive shaft from the fron ...

Reduced Engine Power Light
The reduced engine power light should come on briefly as the engine is started. If it does not come on, have the vehicle serviced by your dealer. This light, along with the malfunction indicator lamp, displays when a noticeable reduction in the vehicle's performance occurs. Stop the vehic ...

© 2011-2024 Copyright www.ccruze.com