Chevrolet Cruze Repair Manual: General Information
- General Information
- US English/Metric Conversion
- Vehicle, Engine and Transmission ID and VIN Location, Derivative and Usage
- Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label
- Fasteners
- Thread Inserts
- Lifting and Jacking the Vehicle
- Air/Wind Noise
- Squeaks and Rattles
- Waterleaks
Test Probe Caution
Caution: Do not insert test equipment probes (DMM etc.) into any
connector or fuse block terminal. The diameter of the test probes will
deform most terminals. A deformed terminal will cause a poor ...
Other materials:
Strut, Strut Component, or Spring Replacement
Special Tools
CH-6068 Spring Tensioner Device
CH-6066 Holding Device
For equivalent regional tools, refer to Special Tools.
Disassembly Procedure
Remove the strut assembly. Refer to Strut Assembly
Replacement.
Install the strut to the CH-6066 holder (5).
Tens ...
Installation Procedure
Install NEW stabilizer shaft insulators (1) to stabilizer shaft (2) so
that the slit in the insulator is facing the rear of the vehicle.
Install the insulator c 2. lamp to the insulator:
2.1. Position the clamp (2) over on the insulator.
2.2. Use two M8 bolts (1, 3) with 40 ...
Front Side Door Replacement
Preliminary Procedure
Remove the front side door trim panel. Refer to Front Side Door Trim
Replacement.
Front Side Door Check Link Bolt
Caution: Refer to Fastener Caution in the Preface section.
Procedure
Remove the water deflector.
Disconnect the door electrical connector.
Su ...
