Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Halogen Bulb Warning

Chevrolet Cruze Repair Manual / Preface / Halogen Bulb Warning

Warning: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

Hood Hold-Open Device Warning

Warning: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Hot Exhaust System Warning

Warning: While engine is operating, the exhaust system will become extremely hot. To prevent burns avoid contacting a hot exhaust system.

Moving Parts and Hot Surfaces Warning

Warning: Avoid contact with moving parts and hot surfaces while working around a running engine in order to prevent physical injury.

Protective Goggles and Glove Warning

Warning: Always wear protective goggles and gloves when removing exhaust parts as falling rust and sharp edges from worn exhaust components could result in serious personal injury.

Fuel and Evaporative Emission Pipe Warning
Warning: In order to reduce the risk of fire and personal injury observe the following items: Replace all nylon fuel pipes that are nicked, scratched or damaged during installation, do not at ...

Relieving Fuel Pressure Warning
Warning: Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury. After you relieve the fuel system pressure, a ...

Other materials:

Moveable Window Schematics
Defogger Schematics Window System Component Views Window Systems Component Views ...

Roof
Sunroof The sunroof only operates when the ignition is in ON/RUN or ACC/ ACCESSORY, or when Retained Accessory Power (RAP) is active. To open or close the sunroof, press the open or close sunroof switch (1) to the first detent position. To express open or close the sunroof with the safety f ...

Installation Procedure
Cut the rocker outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion of the ...

© 2011-2026 Copyright www.ccruze.com