Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Inflatable Restraint Steering Wheel Module Coil Centering

Chevrolet Cruze Repair Manual / Restraints / Inflatable Restraint Steering Wheel Module Coil Centering

Caution: The new SIR coil assembly will be centered. Improper

Caution: The new SIR coil assembly will be centered. Improper alignment of the SIR coil assembly may damage the unit, causing an inflatable restraint malfunction.

  1. Verify the following conditions before centering the supplemental inflatable restraint (SIR) steering  wheel module coil:
  1. Turn the lobe of the clock spring clockwise until the coil ribbon stops. Do not force.
  2. Turn the lobe of the clock spring counterclockwise approximately 3 turns to the Neutral position.

  1. Properly align until the centering window turns yellow (1). This indicates the CENTER position.

Instrument Panel Inflatable Restraint Module Replacement

Warning: Refer to SIR Warning in the Preface section.

Warning: Refer to SIR Warning in the Preface section.

Preliminary Procedure

  1. Disable the SIR system. Refer to  SIR Disabling and Enabling.
  2. Remove the instrument panel assembly. Refer to Instrument Panel Assembly Replacement.

Instrument Panel Inflatable Restraint Module Nut (Qty: 7)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 8 N·m (71 lb in)

Instrument Panel Inflatable Restraint Module Assembly

Tip

Disconnect the electrical connectors.

Steering Wheel Inflatable Restraint Module Coil Replacement
Preliminary Procedure Remove the steering column upper trim cover. Refer to Steering Column Upper Trim  Cover Replacement. Remove the steering column lower trim cover. Refer to Steer ...

Driver or Passenger Seat Side Inflatable Restraint Module Replacement
Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section. Warning: Following the deployment of a side impact air bag, inspect the following parts for damage ...

Other materials:

Installation Procedure
Cut the rear side rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion of the serv ...

Rear Side Door Weatherstrip Replacement - Body Side
Rear Side Door Weatherstrip - Body Side Procedure Start at the front upper corner of the door opening and pull the weatherstrip away from   the door opening flange. Position the weatherstrip in the upper corner of the center pillar. Working downward along the front edge, in ...

Removal Procedure
Turn the front wheels to the straight forward position and secure the steering  wheel from moving. Remove the 2 lower steering intermediate shaft bolts (1). Remove the steering intermediate shaft from the steering gear. Raise and support the vehicle. Refer to Lifting and Jac ...

© 2011-2024 Copyright www.ccruze.com