Chevrolet Cruze Repair Manual: Installation Procedure
- Position the front end upper tie bar (1) on the vehicle.
- Verify the fit of the front end upper tie bar.
- Clamp the front end upper tie bar into position.
- Weld seam accordingly.
- Weld seam accordingly.
- Grind down weld seams as needed for related panels and components.
- Drill 8 mm (5/16 in) for plug welding along the edges of the service
panel as noted from the original panel.
- Clean and prepare the attaching surfaces for welding.
- Position the front end sheet metal cross panel reinforcement (1) on the
vehicle.
- Verify the fit of the front end upper tie bar.
- Clamp the front end sheet metal cross panel reinforcement into position.
- Plug weld accordingly.
- Install front bumper impact bar before applying the sealers and
anti-corrosion materials.
- Apply the sealers and anti-corrosion materials to the repair area, as
necessary. Refer to Anti-Corrosion Treatment and Repair
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems
- Install all related panels and components
- Connect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection
- Enable the SIR system. Refer to SIR Disabling and Enabling
Disable the SIR System. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove all related panels an ...
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed. ...
Other materials:
Tire Messages
SERVICE TIRE MONITOR SYSTEM
This message displays if there is a problem with the Tire Pressure Monitor System
(TPMS).
TIRE LEARNING ACTIVE
This message displays when the system is learning new tires.
TIRE PRESSURE LOW ADD AIR TO TIRE
On vehicles with the Tire Pressure Monitor System (TPMS), t ...
Removal Procedure
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface
section.
Disable the SIR System. Refer to SIR Disabling
and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove the front side door. Refer t ...
Destination
If route guidance is not active, press the Destination Entry screen button on
the Home Page to access the Destination Entry screen. Several options can be selected
to plan a route by entering destinations.
Some destination entry items such as Previous Destinations, Address Book, and
My Home ...