Chevrolet Cruze Repair Manual: Installation Procedure
- Drill 8 mm (5/16 in) for plug welding along the edges of the front wheelhouse panel rear reinforcement as noted from the original panel.
- Drill 8 mm (5/16 in) for plug welding where front wheelhouse front panel and front wheelhouse panel rear reinforcement overlap.
- Clean and prepare the attaching surfaces for welding.
- Position the front wheelhouse panel rear reinforcement on the vehicle.
- Verify the fit of the front wheelhouse panel rear reinforcement.
- Clamp the front wheelhouse panel rear reinforcement into position.
- Plug weld accordingly.
- Plug weld the joint from front wheelhouse panel rear reinforcement to front wheelhouse front panel accordingly.
- Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti- Corrosion Treatment and Repair.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR Syst ...
Front Wheelhouse Panel Rear Reinforcement Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed. ...
Other materials:
Loss of Control
Skidding
There are three types of skids that correspond to the vehicle's three control
systems:
• Braking Skid — wheels are not rolling.
• Steering or Cornering Skid — too much speed or steering in a curve causes tires
to slip and lose cornering force.
• Acceleration Skid — too much thro ...
Horns
Specifications
Horn Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
Horn Nut
Caution: Refer to Fastener Caution in the Preface section.
Tighten
17 N·m (13 lb ft)
Horn
Tip
Disconnect electrical connectors.
St ...
Heating and Air Conditioning System Description and Operation
Engine Coolant
Engine coolant is the key element of the heating system. The thermostat
controls engine operating coolant temperature. The thermostat
also creates a restriction for the cooling system that promotes a positive
coolant flow and helps prevent cavitation. Coolant enters the
heater ...
