Chevrolet Cruze Repair Manual: Installation Procedure
- Cut the front hinge pillar body in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed
to allow a gap of one-and-one-half-times the metal thickness at the
sectioning joint.
- Create a 50 mm (2 in) backing plate from the unused portion of the
service part.
- Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the
sectioning cut on the remaining original part. Locate these holes
13 mm (1/2 in) from the edge of part and spaced 40 mm (1½ in) apart.
- Prepare all mating surfaces as necessary.
- Fit the backing plates halfway into the sectioning joints, clamp in
place and braze to the vehicle.
- Align the front hinge pillar body.
- Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing in locations
where you can not apply a resistance spot welder.
- Clean and prepare the attaching surfaces for brazing.
Note: In MIG-brazing areas 50 mm (2 in) must be kept clear of
structural adhesive.
- Apply structural adhesive to all attaching surfaces.
- Position the front hinge pillar body on
the vehicle.
- Verify the fit of the front hinge pillar body.
- Clamp the front hinge pillar body into position.
- Plug weld accordingly.
- Spot weld accordingly.
- To create a solid braze with minimum heat distortion, make 25 mm (1 in)
stitch brazes along the seam with 25 mm (1 in) gaps
between them. Then go back and complete the stitch braze.
- Apply the sealers and anti-corrosion materials to the repair area, as
necessary. Refer to Anti-Corrosion Treatment and Repair.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and She ...
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed. ...
Other materials:
Hood Replacement
Warning: When a hood hold open device is being removed or installed,
provide alternate support to avoid the possibility of
damage to the vehicle or personal injury.
Preliminary Procedure
Remove the windshield washer nozzle hose. Refer to Windshield Washer Nozzle
Hose Replacement.
Hood ...
Front Side Door Window Weatherstrip Replacement
Preliminary Procedure
Remove the outside rearview mirror. Refer to Outside Rearview
Mirror Replacement.
Remove the front side door window frame rear cover. Refer to Front Side
Door Window Frame Rear Cover Replacement.
Front Side Door Window Weatherstrip
Procedure
Pull the ...
Steering Linkage Outer Tie Rod Replacement
Preliminary Procedure
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and
Installation.
Steering Linkage Tie Rod Nut
Caution: Refer to Fastener Caution in the Preface section.
Tighten
35 N·m (26 lb ft)
Steering Linkage Inner Tie Rod Nut
Tighten
60 N·m (44 ...