Chevrolet Cruze Repair Manual: Installation Procedure
- Align the rocker inner panel.
- Drill 8 mm (5/16 in) for plug welding along the edges of the quarter
outer panel as noted from the original panel.
- Clean and prepare the attaching surfaces for welding.
- Position the rocker inner panel on the vehicle.
- Verify the fit of the quarter outer panel.
- Clamp the rocker inner panel into position.
- Plug weld accordingly
- Plug weld accordingly.
- To create a solid weld with minimum heat distortion, make 25 mm (1 in)
stitch welds along the seam with 25 mm (1 in) gaps
between them. Then go back and complete the stitch weld.
- Apply the sealers and anti-corrosion materials to the repair area, as
necessary. Refer to Anti-Corrosion Treatment and Repair.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and She ...
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed. ...
Other materials:
Removal Procedure
Warning: Refer to Glass and Sheet Metal Handling Warning in the
Preface section.
Disable the SIR System. Refer to SIR
Disabling and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove the rear side door. Refer t ...
Power Door Locks Description and Operation
Door Lock System Components
The power door lock system consists of the following components:
Door lock switch - located in the center of the instrument panel
Body control module (BCM)
Driver door latch
Passenger door latch
Left rear door latch
Right rear door latch
Door Lock System ...
Washer Fluid
What to Use
When windshield washer fluid is needed, be sure to read the manufacturer's instructions
before use. If operating the vehicle in an area where the temperature may fall below
freezing, use a fluid that has sufficient protection against freezing.
Adding Washer Fluid
Open the ca ...