Chevrolet Cruze Repair Manual: Installation Procedure
- Create 6 x 20 mm (4/16 x 11/16 in) slots for MIG-brazing along the upper
edges of the service panel as noted from the original
panel.
- Clean and prepare the attaching surfaces for brazing and spot welding.
- Position the body lock pillar inner panel on the vehicle.
- Verify the fit of the panel.
- Clamp the body lock pillar inner panel into position.
- Braze accordingly the body lock pillar inner panel upper.
- Spot weld accordingly the body lock
pillar inner panel lower.
- Apply the sealers and anti-corrosion materials to the repair area, as
necessary. Refer to Anti-Corrosion Treatment and Repair.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR Syst ...
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed. ...
Other materials:
Starter Switch Check
WARNING
When you are doing this inspection, the vehicle could move suddenly. If the
vehicle moves, you or others could be injured.
1. Before starting this check, be sure there is enough room around the vehicle.
2. Firmly apply both the parking brake and the regular brake.
Do not use the accele ...
Power Windows
WARNING
Children could be seriously injured or killed if caught in the path of a closing
window. Never leave keys in a vehicle with children. When there are children in
the rear seat, use the window lockout button to prevent operation of the windows.
Press the switch down to open the window. ...
License Plate Lamp
To replace the license plate lamp bulb:
1. Remove the two screws from the license plate lamp assembly.
2. Turn and pull the license plate lamp assembly down.
3. Turn the bulb socket counterclockwise and pull straight out of the lamp assembly.
4. Remove the bulb by pulling it straight out of ...