Chevrolet Cruze Repair Manual: Installation Procedure
- Cut the rocker outer panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioning
joint.
- Create a 50 mm (2 in) backing plate from the unused portion of the
service part.
- Drill 8 mm (5/16 in) along the sectioning cut on the remaining original
part. Locate these holes 13 mm (1/2 in) from the edge of part
and spaced 40 mm (1½ in) apart.
- Prepare all mating surfaces as necessary.
- Fit the backing plates halfway into the sectioning joints, clamp in
place and plug weld to the vehicle.
- Align the rocker outer panel.
- Drill 8 mm (5/16 in) for plug welding along the edges of the rocker
outer panel as noted from the original panel.
- Clean and prepare the attaching surfaces for welding.
- Position the rocker outer panel on the
vehicle.
- Verify the fit of the rocker outer panel.
- Clamp the rocker outer panel into position.
- Plug weld accordingly.
- To create a solid weld with minimum heat distortion, make 25 mm (1 in)
stitch welds along the seam with 25 mm (1 in) gaps
between them. Then go back and complete the stitch weld.
- Apply the sealers and anti-corrosion materials to the repair area, as
necessary. Refer to Anti-Corrosion Treatment and Repair.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and She ...
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed. ...
Other materials:
Retained Accessory Power (RAP)
These vehicle accessories may be used for up to 10 minutes after the engine is
turned off:
• Audio System
• Power Windows
• Sunroof
The power windows and sunroof will continue to work for up to 10 minutes or until
any door is opened. The radio will work when the key is in ON/RUN or ACC/ ACCE ...
Instrument Panel Wiring Harness Replacement
Removal Procedure
Remove instrument panel compartment assembly. Refer to Instrument
Panel Compartment Replacement.
Remove instrument panel wiring harness (2) from instrument panel tie bar
(1).
Disconnect electrical connectors.
Installation Procedure
Ins ...
Removal Procedure
Remove the drivetrain and front suspension frame. Refer to Drivetrain
and Front Suspension Frame Replacement.
Mark Installation position of insulator (2) at frame (1).
Cut out frame insulator core (1) from frame insulator (2).
Note: On the rear insulator dril ...