Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Installation Procedure

  1. Align the rear compartment floor panel.

  1. Drill 4 mm (3/16 in) for rivets along the edges of the rear compartment floor were you cant apply a resistance spot welder.
  2. Clean and prepare the attaching surfaces for   spot welding and riveting.
  3. Apply structural adhesive to all attaching surfaces.
  4. Position the rear compartment floor panel on the vehicle.
  5. Verify the fit of the rear compartment floor panel.
  6. Clamp the rear compartment floor panel into position.
  7. Rivet the rear compartment floor panel.

  1. Spot weld accordingly.

  1. Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges of the floor panel rear reinforcement, the spare wheel carrier bracket and the rear wheelhouse panel rear brace as noted from the original panel.
  2. Clean and prepare the attaching surfaces for brazing.
  3. Position the floor panel rear reinforcement, the spare wheel carrier bracket and the rear wheelhouse panel rear brace on the vehicle.
  4. Verify the fit of the floor panel rear reinforcement, the spare wheel carrier bracket and the rear wheelhouse panel rear brace.

  1. Braze accordingly.
  2. Weld accordingly the weld studs as noted.
  3. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
  4. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
  5. Install all related panels and components
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Rear Wheelhouse Panel Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Other materials:

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR Disabling and Enabling. Disconnect the negative battery cable. Refer to Batter ...

Instrument Panel Illumination Control
This feature controls the brightness of the instrument panel controls and infotainment display screen. The thumbwheel is to the left of the steering column on the instrument panel. (Instrument Panel Brightness): Move the thumbwheel up or down and hold, to brighten or dim the instrument pan ...

Doing Your Own Service Work
WARNING It can be dangerous to work on your vehicle if you do not have the proper knowledge, service manual, tools, or parts. Always follow owner manual procedures and consult the service manual for your vehicle before doing any service work. If doing some of your own service work, use the pro ...

© 2011-2024 Copyright www.ccruze.com