Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in).
Installation Procedure
Cut the front hinge pillar body in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed
to allow a gap of one-and-one-half-times the metal thickness at the
sectioning joint.
Create a 50 mm (2 in) backing plate from the unused portion of ...
Vehicle Positioning
At times, the position of the vehicle on the map could be inaccurate due to one
or more of the following reasons:
• The road system has changed.
• The vehicle is driving on slippery road surfaces such as sand, gravel, or snow.
• The vehicle is traveling on winding roads or long straight roads.
...
Lifting and Jacking the Vehicle
Note: The use of a LOW PROFILE LIFT ARMS SYSTEM may be required to
avoid unwanted contact with the vehicle's body and structure
depending on lifting equipment used. Refer to the manufacture's recommendation
for their applications of low profile lift arms system for
their lifting equipment.
...