Chevrolet Cruze Repair Manual: Installation Procedure
- Clean and prepare the attaching surfaces for brazing.
- Apply structural adhesive to the attaching surfaces.
- Position the rear bumper impact bar stud plate on the vehicle.
- Verify the fit of the rear bumper impact bar stud plate
- Clamp the rear bumper impact bar stud plate into position.
- Spot weld accordingly.
- Apply the sealers and anti-corrosion materials to the repair area, as
necessary. Refer to Anti-Corrosion Treatment and Repair.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR Syst ...
Special Tools
BO-6396 Bonding Pliers
BO-6392 Flanging Tool Kit
For equivalent regional tools, refer to Special Tools
Note: According to different corrosion warranties, only the
regional ma ...
Other materials:
Rear Compartment Lid Emblem/Nameplate Replacement (Rear Emblem)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the
Preface section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
Hood Primary Latch Release Cable Handle Replacement
Preliminary Procedure
Remove the front side door sill trim plate. Refer to Front Side Door Sill
Trim Plate Replacement.
Hood Primary Latch Release Cable Handle
Procedure
Pull down the hood primary latch release cable handle.
To release the handle, pull down the cable and unhook ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Dis ...