Chevrolet Cruze Repair Manual: Installation Procedure
- Apply structural adhesive on the flanges of the rear side door inner
panel where the rear side door outer panel bears on.
- Align the rear side door outer panel.
- Verify the fit of the rear side door outer panel.
- Clamp the rear side door outer panel
into position.
- Pre-flanging the flange with BO-6396 pliers and BO-6392 tool kit .
- Continue to hammer in stages along the hem flanges.
- Apply the sealers and anti-corrosion materials to the repair area, as
necessary. Refer to Anti-Corrosion Treatment and Repair.
- Install the rear side door outside handle. Refer to Rear Side Door
Outside Handle Replacement.
- Install the rear side door. Refer to Rear Side Door Replacement.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Connect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection
- Enable the SIR system. Refer to SIR Disabling and Enabling.
Warning: Refer to Glass and Sheet Metal Handling Warning in the
Preface section.
Disable the SIR System. Refer to SIR
Disabling and Enabling.
Disconnect the negative battery cable. R ...
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed. ...
Other materials:
Rear Compartment Lid Weatherstrip Replacement
Rear Compartment Lid Weatherstrip
Procedure
Start at the upper corner of the rear compartment opening and pull the
weatherstrip away from the rear
compartment opening flange.
Position the weatherstrip in the upper corner of the r 2. ear
compartment opening.
Working downward alon ...
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the brake rotor. Refer to Front Brake Rotor Replacement.
Remove the wheel speed sensor screw (2).
Remove the wheel speed sensor (1) from the steering knuckle.
Remove the wheel drive shaft from the fron ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling
and Enabling.
Disconnect the negative battery cable. Refer to ...