Chevrolet Cruze Repair Manual: Installation Procedure

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Tail Lamp Pocket Replacement (MIG-Brazing) / Installation Procedure

Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges of the tail lamp pocket as noted f rom the original panel.

Note:

Clean and prepare the attaching surfaces for brazing.

Position the tail lamp pocket on the vehicle.
Verify the fit of the tail lamp pocket.
Clamp the tail lamp pocket into position.

Braze accordingly.
Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
Install all related panels and components.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
Enable the SIR system. Refer to SIR Disabling and Enabling.

Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

This information provides repair recommendations and general guidelines for steel classified as Dual Phase Steel (Dual Phase Steel with a tensile strength up to and including 800 MPa), also known a ...

Other materials:

Rear Spring Replacement
Removal Procedure Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle. Support the rear axle with a tall jack stand near the shock absorber. Remove the lower shock bolt. Refer to Shock Absorber Replacement. Using the tall jack stands, slowly lower the rear a ...

Customer Assistance Offices
Chevrolet encourages customers to call the toll-free number for assistance. However, if a customer wishes to write or e-mail Chevrolet, the letter should be addressed to: United States and Puerto Rico Chevrolet Motor Division Chevrolet Customer Assistance Center P.O. Box 33170 Detroit, MI 4 ...

Front Brake Rotor Replacement
Special Tools CH-41013 Rotor Resurfacing Kit CH-42450-A Wheel Hub Resurfacing Kit For equivalent regional tools, refer to Special Tools. Removal Procedure Warning: Refer to Brake Dust Warning in the Preface section. Raise and support the vehicle. Refer to Lifting and Jacking ...