Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Instrument Panel Lower Trim Pad Cover Replacement

Chevrolet Cruze Repair Manual / Body hardware and trim / Instrument Panel and Console Trim / Instrument Panel Lower Trim Pad Cover Replacement

Preliminary Procedure

Preliminary Procedure

Remove the left outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement - Left Side.

  1. Instrument Panel Lower Trim Pad Cover Screw (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m (23 lb in)

  1. Instrument Panel Lower Trim Pad Cover Assembly

Procedure

  1. Remove headlamp switch.
  2. Disconnect the electrical connectors.
  3. When replacing the lower trim pad cover, transfer all necessary components.

Instrument Panel Lower Trim Panel Replacement - Left Side

  1. Instrument Panel Lower Trim Panel Replacement - Left Side
Instrument Panel Accessory Bezel Replacement
Preliminary Procedure Remove transmission control cover. Refer to Automatic or Manual Transmission Control Lever Trim Cover Replacement. Instrument Panel Accessory Bezel Screw (Qty: 4) C ...

Instrument Panel Cluster Lower Trim Plate Replacement
Preliminary Procedure Remove instrument panel cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Replacement. Instrument Panel Cluster Lower Trim Plate Screw (Qty: 4) Cauti ...

Other materials:

Wheel Stud Replacement
Removal Procedure Raise and suitably support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. Remove the wheel bearing/hub. Refer to Rear Wheel Bearing and Hub Replacement. Cauti ...

Driver or Passenger Seat Replacement
Removal Procedure Warning: Refer to SIR Warning in the Preface section. Warning: When carrying a live inflator module, make sure the bag opening is pointed away from you. This minimizes the chance of injury in the case of an accidental deployment. Never carry the inflator module by the wi ...

Battery Disconnect Warning
Warning: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact ...

© 2011-2025 Copyright www.ccruze.com