Chevrolet Cruze Repair Manual: Intermediate Steering Shaft Replacement
Removal Procedure
- Turn the steering wheel to the straight forward position and support it from movement
- Remove the 2 intermediate steering shaft bolts (1).
- Remove the intermediate steering shaft (1).
Installation Procedure
- Install the intermediate steering shaft (1).
Note: The recess (2) of the fine toothing in the universal joint have to align precisely with the recess (1) of the fine toothing on the steering pinion. The bore in the universal joint has to align with the groove on the steering pinion (3).
- Push universal joint onto steering pinion carefully as desribed above inthe note.
Caution: Refer to Fastener Caution in the Preface section.
- Install the 2 intermediate steering shaft bolts (1). Tighten the intermediate steering shaft bolts 34 N·m (25 lb ft).
Steering Column Upper Trim Cover Replacement
Steering Column Upper Trim Cover
Procedure
Unclip the steering column upper trim cover from the steering column lower trim cover.
Steering Column Lower Trim Cover Replacement
Preliminary Procedure
Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement.
- Steering Column Lower Trim Cover Bolt (Qty: 3)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m (22 lb in)
- Steering Column Lower Trim Cover
Procedure
Turn the steering wheel until the bolts are reachable.
Steering Wheel and Column
Specifications
...
Turn Signal Switch Replacement
Preliminary Procedure
Remove the steering column upper trim cover. Refer to Steering Column
Upper Trim Cover Replacement.
Remove the steering column lower trim cover. Refer to Steer ...
Other materials:
Map Data Updates
The map data in the vehicle is the most up-to-date information available when
the vehicle was produced. The map data is updated periodically, provided that the
map information has changed.
For questions about the operation of the navigation system or the update process,
contact the GM Nav Dis ...
Body Waterleak Repair
Warning: If the vehicle interior is exposed to moisture and becomes
soaked up to the level of the sensing and diagnostic module (SDM),
the SDM and SDM harness connector must be replaced. The SDM could be activated
when powered, which could cause airbag deployment
and result in personal inj ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Disable the SIR System. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove all related panels and ...
