Chevrolet Cruze manuals

Chevrolet Cruze Infotainment System: Map Data Updates

The map data in the vehicle is the most up-to-date information available when the vehicle was produced. The map data is updated periodically, provided that the map information has changed.

For questions about the operation of the navigation system or the update process, contact the GM Nav Disc Center toll-free phone number, 1-877-NAV-DISC (1-877-628-3472) or go to the center’s website, www.gmnavdisc.com. If updates are needed, call the GM Nav Disc Center or order a new Map Update online. To order map data, have the vehicle’s Vehicle Identification Number (VIN) available.

If the System Needs Service
If the navigation system needs service and the steps listed here have been followed but there are still problems, see your dealer for assistance. ...

Database Coverage Explanations
Coverage areas vary with respect to the level of map detail available for any given area. Some areas feature greater levels of detail than others. If this happens, it does not mean there is a probl ...

Other materials:

Front Side Door Weatherstrip Replacement - Door Side
Front Side Door Check Bolt Caution: Refer to Fastener Caution in the Preface section. Tighten 25 N·m (19 lb ft) Front Side Door Weatherstrip - Door Side Procedure Unclip weatherstrip 1. from front side door. When removing protective liners from adhesive tape, be careful no ...

Front Fender Emblem/Nameplate Replacement (1.8L 2H0 or 2.0L Diesel)
Front Fender Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop suff ...

Rear Compartment Lid Emblem/Nameplate Replacement (VCDi AT)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

© 2011-2026 Copyright www.ccruze.com