This information provides repair recommendations and general guidelines for steel classified as Mild Steel. This type of steel normally has a tensile strength less than 270 MPa. This includes the common steel names of:
General Motors recommends the following when repairing or replacing this type of steel during collision repair.
Recommended Repairs:
Installation Procedure
Create 8 x 14 mm (5/16 x 15/16 in) slots for MIG-Brazing along the edges
of the drivetrain and front suspension frame front support
as noted from the original panel.
Clean and prepare the attaching surfaces for brazing.
Position the drivetrain and front suspension frame ...
Compass
The vehicle may have a compass display in the Driver Information Center (DIC).
The compass receives its heading and other information from the Global Positioning
System (GPS) antenna, StabiliTrak, and vehicle speed information.
Avoid covering the GPS antenna, located on the roof, for long perio ...
Reporting Safety Defects to the United States Government
If you believe that your vehicle has a defect which could cause a crash or could
cause injury or death, you should immediately inform the National Highway Traffic
Safety Administration (NHTSA) in addition to notifying General Motors.
If NHTSA receives similar complaints, it may open an investig ...