OnStar navigation requires the Directions and Connections service plan.
Press
to receive directions or have
them sent to the vehicle navigation screen, if equipped.
Destinations can also be forwarded to the vehicle from MapQuest.com.
The OnStar mapping database is continuously updated. For coverage maps, see www.onstar.com (U.S.) www.onstar.ca (Canada).
Turn-by-Turn Navigation
1. Press
to connect to a live Advisor.
2. Request directions.
3. Directions are downloaded to the vehicle.
4. Follow the voice-guided commands.
Using Voice Commands During a Planned Route
Cancel Route
1. Press
. System responds: “OnStar
ready,” then a tone. Say “Cancel route.” System responds: “Do you want to cancel
directions?”
2. Say “Yes.” System responds: “OK, request completed, thank you, goodbye.”
Route Preview
1. Press
. System responds: “OnStar
ready,” then a tone.
2. Say “Route preview.” System responds with the next three maneuvers.
3. Say “Goodbye.” Exits voice commands.
Repeat
1. Press
. System responds: “OnStar
ready,” then a tone.
2. Say “Repeat.” System responds with the last direction given, then responds with “OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
Get My Destination
1. Press
. System responds: “OnStar
ready,” then a tone.
2. Say “Get my destination.” System responds with address and the distance to the destination, then responds with “OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
Other Navigation Services Available from OnStar
OnStar eNav
: Allows subscribers to send destinations from MapQuest.com to their Turn-by-Turn Navigation or screen-based navigation system. When ready, the directions will be downloaded to the vehicle.
Destination Download:
Press
, then request the Advisor to download
directions to the navigation system in the vehicle.
After the call ends, press the “Go” button on the navigation screen to begin driving directions.
Destinations can also be downloaded on the go. For information about eNav, Destination Download, and coverage maps see www.onstar.com (U.S.), www.onstar.ca (Canada).
Security
ConnectionsRear Side Door Weatherstrip Replacement - Door Side
Rear Side Door Check Bolt
Caution: Refer to Fastener Caution in the Preface section.
Tighten
25 N·m (19 lb ft)
Rear Side Door Weatherstrip - Door Side
Procedure
Unclip weatherstrip from rear side door.
When removing protective liners from adhesive tape, be care ...
Driver Seat Frame Replacement
Removal Procedure
Remove front seat cushion cover (1) and pad (2) from frame (3). Refer to
Front Seat Cushion Cover and Pad Replacement
Remove the wire harness (1), if equipped.
Remove front seat back cushion cover (1) and pad (2) from frame (3).
Refer to Driver or ...
Installation Procedure
Clean and prepare the attaching surfaces for welding.
Apply one-part windshield urethane adhesive as noted from the original
panel.
Position the roof panel (1) on the
vehicle.
Verify the fit of the panel.
Clamp the panel into position.
Spot weld accor ...