Chevrolet Cruze Owners Manual: OnStar Overview
If equipped, this vehicle has a comprehensive, in-vehicle system that can connect to a live Advisor for Emergency, Security, Navigation, Connection, and Diagnostic Services.
The OnStar system status light is next to the OnStar buttons. If the status light
is:
• Solid Green: System is ready.
• Flashing Green: On a call.
• Red: Indicates a problem.
Press 
or call 1-888-4ONSTAR (1-888-466-7827)
to speak to an Advisor.
Press 
to:
• Make a call, end a call, or answer an incoming call.
• Give OnStar Hands-Free Calling voice commands.
• Give OnStar Turn-by-Turn Navigation voice commands.
Requires the available Directions and Connections service plan.
Press to connect to a live Advisor
to:
• Verify account information or update contact information.
• Get driving directions. Requires the available Directions and Connections service plan.
• Receive On-Demand Diagnostics for a check of the vehicle’s key operating systems.
• Receive Roadside Assistance.
Press the OnStar Emergency button 
to get a priority connection to an Emergency Advisor available 24/7 to:
• Get help for an emergency.
• Be a Good Samaritan or respond to an AMBER Alert.
• Get crisis assistance and evacuation routes.
OnStar
...
OnStar Services
...
Other materials:
Installation Procedure
Position the front end upper tie bar (1) on the vehicle.
Verify the fit of the front end upper tie bar.
Clamp the front end upper tie bar into position.
Weld seam accordingly.
Weld seam accordingly.
Grind down weld seams as needed for related panels and components.
...
Rear Bumper Fascia Outer Guide Replacement
Preliminary Procedure
Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement.
Rear Bumper Fascia Outer Guide Rivet (Qty: 3)
Special Tools
BO-594-A Hand Rivet Tongs
For equivalent regional tools, refer to Special Tools.
Rear Bumper Fascia Outer Guide
...
Shock Absorber Disposal
Warning: Use the proper eye protection when drilling to prevent
metal chips from causing physical injury.
Clamp the strut in a vise horizontally with the rod ( 1) completely
extended.
Drill a hole in the strut at the center of the end cap (3) using a 5 mm
(3/16 in) drill bit. Gas o ...
