Pictures can only be viewed using USB devices. If pictures are on an SD card, transfer to a USB device or use a USB-SD adapter. File sizes above approximately four mega pixels may not show. Only jpeg, bmp, gif, and png files are supported.
1. Press the Pictures screen button on the Home Page.
2. The system does a search to find the picture folders.
A “Please wait” message displays until the search is finished.

3. A list displays. Select a picture to view.

4. Once a picture displays, the following options are available: Info
: Press to turn file name information on or off.
: Press to display a previous picture
if not in slide show mode.
: Press to toggle between slide show
mode and manual mode.
: Press to display a next picture
if not in slide show mode.
: Press to manually rotate a picture
90 degrees counterclockwise.
Menu
: Press to open the Picture Viewer Settings screen. Slide Picture Viewer Main, Slideshow Timer, and Shuffle Images display as options for configuring the view of images stored in the system.
If the displayed picture screen is not used within six seconds, the upper and lower bar options will disappear.
Touch-tap the screen to re-display the upper and lower bar.
Stitcher Internet Radio
Audio PlayersInstallation Procedure
Cut the front hinge pillar body in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed
to allow a gap of one-and-one-half-times the metal thickness at the
sectioning joint.
Create a 50 mm (2 in) backing plate from the unused portion of ...
Interior Trim and Paneling
Specifications
Front Side Door Window Switch Bezel Replacement
Preliminary Procedure
Remove the front side door trim. Refer to Front Side Door Trim Replacement.
Front Side Door Window Switch Bezel Screw (Qty: 8)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
...
Shock Absorber Disposal
Warning: Use the proper eye protection when drilling to prevent
metal chips from causing physical injury.
Clamp the strut in a vise horizontally with the rod ( 1) completely
extended.
Drill a hole in the strut at the center of the end cap (3) using a 5 mm
(3/16 in) drill bit. Gas o ...