Door Lock System Components
The power door lock system consists of the following components:
Door Lock System Controls
The power door lock system can be controlled by any of the following:
Door Lock and Unlock Operation
When a door lock switch is activated in the lock or unlock position the BCM will receive a ground signal on either the door lock switch lock or unlock signal circuits.
The BCM, upon receipt of a lock switch lock or unlock signal, will supply battery voltage to the door lock actuator lock or unlock control circuits. Since the opposite side of the lock actuator is connected to ground through the other lock actuator control circuit, the doors, fuel filler door and liftgate will then lock or unlock as commanded.
The following three circuits are used to operate the lock:
The driver door lock actuator is isolated so it can be unlocked by itself using the keyless entry transmitter.
Automatic Door Lock Operation
This feature can be personalized to driver preference.
The BCM will automatically lock the vehicle doors if the following conditions exist:
The BCM will then unlock the doors when vehicle is shifted back into Park.
Delayed Locking Operation
With any door open and a door lock switch is activated in the lock position, the BCM will give three audible chimes. When the door is closed, the BCM will cycle the internal door lock relay to lock the doors after approximately five seconds. This feature can be overridden by activating the door lock switch a second time and the doors will lock even with a door open.
Lockout Prevention Operation
The BCM will lock all doors and unlock the driver door with a door lock switch lock activation if a vehicle door is open and the ignition key is fully inserted in the ignition. The lockout prevention feature can be overridden if a lock command is received from the keyless entry system.
Special Tools and Equipment
Manual Transmission
Shift Pattern
All Models Except Fuel Economy Model
Fuel Economy Model
These are the shift patterns for the six-speed manual transmissions.
To operate the transmissions:
Notice: Do not rest your hand on the shift lever while driving. The
pressure could cause premature wear in the transmiss ...
Trademarks and License Agreements
FCC Information
See “Radio Frequency Statement” in the owner manual for information regarding
Part 15 of the Federal Communications Commission (FCC) rules and with Industry Canada
Standards RSS-GEN/210/220/310.
“Made for iPod” and “Made for iPhone” mean that an electronic accessory has been ...
Forward Lamp Wiring Harness Replacement
Preliminary Procedures
Remove the front bumper. Refer to Front Bumper Fascia Replacement.
Remove the headlamp. Refer to Headlamp Replacement.
Using a scan tool, check for DTCs.
Forward Lamp Wiring Harness
Tip
Create a work area large enough to lay out the new and old wiring
ha ...