Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Power Steering Pump Belt Replacement

Chevrolet Cruze Repair Manual / Additional links / Power Steering Pump Belt Replacement

Special Tools

CH 49800 Installer Power Steering Pump Belt

For equivalent regional tools, refer to Special Tools.

Removal Procedure

Caution: Do not use belt dressing on the drive belt. Belt dressing causes the breakdown of the composition of the drive belt. Failure to follow this recommendation will damage the drive belt.

  1. Open the hood

  1. Cut the power steering pump belt (2) with a appropriate cutting tool at position (1).
  2. Remove the power steering pump belt (2)

Installation Procedure

  1. Relieve the tension of the drive belt (1). Refer to Drive Belt Replacement.
  2. Install CH-49800 installer (3) on the power steering pump pulley.
  3. Install NEW power steering belt (2) aligning pulley water pump.
  4. Rotate the power steering pump pulley clockwise using hex wrench on the shaft power steering pump pulley.
  5. Remove the CH-49800 installer (3).
  6. Check the belt is installed clearly.
  7. Install the drive belt. Refer to Drive Belt Installation
  8. Close the hood.
Exhaust Flexible Pipe Replacement (1.6L LXT)
Removal Procedure Warning: Refer to Hot Exhaust System Warning in the Preface section. Warning: Refer to Protective Goggles and Glove Warning in the Preface section. Open the hood. Raise the ...

Front Brake Rotor Replacement
Special Tools CH-41013 Rotor Resurfacing Kit CH-42450-A Wheel Hub Resurfacing Kit For equivalent regional tools, refer to Special Tools. Removal Procedure Warning: Refer to Brake Dust Warni ...

Other materials:

Tyre Dismounting and Mounting
Caution: Use a tire changing machine in order to dismount tires. Do not use hand tools or tire irons alone in order to remove the tire from the wheel. Damage to the tire beads or the wheel rim could result. Caution: Do not scratch or damage the clear coating on aluminum wheels with the tire ...

Information Displays
Driver Information Center (DIC) The DIC displays information about your vehicle. It also displays warning messages if a system problem is detected. DIC Operation and Displays The DIC has different displays which can be accessed by using the DIC buttons on the turn signal lever. The DIC displ ...

High Strength Low Alloy Steel
This information provides repair recommendations and general guidelines for steel classified as High Strength Low Alloy Steel, also known as HSLA. This type of steel normally has a tensile strength range from 300-700 MPa. General Motors recommends the following when repairing or replacing th ...

© 2011-2026 Copyright www.ccruze.com