Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Power Steering Warning Light

This light comes on briefly when the ignition is turned to ON/RUN as a check

This light comes on briefly when the ignition is turned to ON/RUN as a check to show it is working.

If it does not come on have the vehicle serviced by your dealer.

If this light stays on, or comes on while driving, the system may not be working. If this happens, see your dealer for service.

Up-Shift Light
For manual transmission vehicles, there is an up-shift light that comes on in the lower DIC area. It shows when to shift to the next higher gear for best fuel economy. ...

Traction Off Light
This light comes on briefly while starting the engine. If it does not, have the vehicle serviced by your dealer. If the system is working normally, the indicator light then turns off. The tract ...

Other materials:

Front Brake Rotor Replacement
Special Tools CH-41013 Rotor Resurfacing Kit CH-42450-A Wheel Hub Resurfacing Kit For equivalent regional tools, refer to Special Tools. Removal Procedure Warning: Refer to Brake Dust Warning in the Preface section. Raise and support the vehicle. Refer to Lifting  and Jacking ...

Rear Axle Replacement
Special Tools EN 45059 Torque Angle Sensor Kit For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and suitably support the vehicle. Refer to Lifting   and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and ...

Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges of the tail lamp pocket as noted f  rom the original panel. Note: Clean and prepare the attaching surfaces for brazing. Position the tail lamp pocket on the vehicle. Verify the fit of the ta ...

© 2011-2026 Copyright www.ccruze.com