Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rail Dust Damage Repair

Warning: Refer to Eye Protection Warning in the Preface section.

Note: If rail dust has penetrated into the basecoat, the panel requires refinishing. Ensure all the rail dust has been removed prior to refinishing or the rust spots will return.

Rail dust damage comes from the tiny iron particles produced from the friction between the train wheels and the track. It can also be deposited on vehicles if stored near any operation producing iron dust (i.e., steel ore yards). This dust can either lay on top of, or embed into the paint surface. It is usually diagnosed as bumps in the paint surface or rust colored spots in the paint.

  1. Move the vehicle to a cool shaded area and ensure the vehicle surfaces are cool   during the removal process.
  2. Thoroughly wash the repair area with a GM approved Liquid Wash and Wax kit
  3. Wipe the area dry.
  4. Clean the affected area with silicone, wax and grease remover.
  5. Perform the removal process according to the manufacturer's directions of the type of repair material used (Gel Type Oxalic Acid or Clay Type Non-Acid Based). If, upon inspection, some particles are still present, the process may be repeated. If the damage has been repaired, complete the repair to the entire panel
  6. Polish the entire panel after the removal process. If small pits remain in the clearcoat after all of the damage has been repaired, refer to Clearcoat Repair without Repainting.
Paint Gauges
Paint thickness gauge. measure the total thickness of the vehicle finish. It is important to accurately measure the thickness of the finish on each vehicle as the thickness of the finish will vary ...

Plastic Panel Information and Repair
...

Other materials:

Airbag Readiness Light
This light shows if there is an electrical problem with the airbag system. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules, the wiring, and the crash sensing and diagnostic module. The airbag readiness light comes on for several ...

Radio Reception
Frequency interference and static can occur during normal radio reception if items such as cell phone chargers, vehicle convenience accessories, and external electronic devices are plugged into the accessory power outlet. If there is interference or static, unplug the item from the accessory p ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the drivetrain and front suspension frame front support as noted from the original panel. Clean and prepare the attaching   surfaces for welding. Position the drivetrain and front suspension frame front suppor ...

© 2011-2024 Copyright www.ccruze.com