Chevrolet Cruze Repair Manual: Rear Bumper Impact Bar Replacement
Preliminary Procedure
Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement.
- Rear Bumper Energy Absorber Nut (Qty: 6)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 40 N·m (30 lb ft)
- Rear Bumper Impact Bar
Special Tools and Equipment
Rear Bumper Fascia Outer Guide Replacement
Preliminary Procedure
Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement.
Rear Bumper Fascia Outer Guide Rivet (Qty: 3)
Special Tools
BO-594-A Hand Rivet Tongs
For eq ...
Collision Repair
Specifications
Point-to-point measurements are for reference only. All measurements are
given in millimeters. Use these measurements for diagnosing
and estimating. Point-to-point measurements ...
Other materials:
Steering Angle Sensor Calibration Warning
Warning: For vehicles with electric power steering (EPS) and without
a vehicle stability enhancement program, the steering angle sensor
MUST always be calibrated after the battery has been disconnected. Failure to
calibrate the steering angle sensor could limit the operation
of the EPS system ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer ...
Rear Compartment Lid Emblem/Nameplate Replacement (CDX)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface
section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
