Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Side Door Outside Handle Rod Adjustment

Chevrolet Cruze Repair Manual / Body systems / Vehicle Access / Rear Side Door Outside Handle Rod Adjustment

Removal Procedure

  1. Remove the rear door water deflector as needed. Refer to Rear Side Door Water Deflector Replacement.
  2. Use a flat-head tool to open the clip from the threaded rod connecting the lock to the outside handle.
  3. Adjust the travel of the handle by removing the threaded rod from the clip.

Installation Procedure

  1. Position the outside door handle rod (2) in the clip (1) in order to eliminate any free play in the outside door handle.
  2. Install the clip cover closed over the threaded outside door handle rod.
  3. Inspect the door lock system for proper operation.
  4. Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement.

Rear Compartment Lid Latch Striker Replacement

Preliminary Procedure

Preliminary Procedure

Remove the rear compartment sill trim plate. Refer to Rear Compartment Sill Trim Plate Replacement.

  1. Rear Compartment Lid Latch Striker Bolt (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Use a grease pencil to outline the striker before removing the bolts.

Tighten 9 N·m (80 lb in)

  1. Rear Compartment Lid Latch Striker

Tip

Adjust the rear compartment lid latch striker after replacing, if needed.

Door Lock Switch Replacement

  1. Door Lock Switch Screw (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 1.5 N·m (13 lb in)

  1. Door Lock Switch

Tip

Disconnect electrical connector.

Vehicle Access
Specifications Door Lock/Indicator Schematics Door Control Module Schematics Release Systems Schematics Fuel Tank Filler Door Lock Actuator Replacement ...

Door Ajar Indicator Description and Operation
Door Ajar Indicator System Components The door ajar indicator system consists of the following components: Body control module (BCM) Instrument cluster Driver information center Driver door ...

Other materials:

How To Indentify Plastic Parts
Plastic parts can be identified by the SAE code, which is usually found on the rear of the part, and/or by the characteristics of the plastic. Knowing the type of plastic aids in selecting the proper repair materials and in selecting the proper repair procedure. Look for the SAE code s ...

Uniform Tire Quality Grading
Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example: Treadwear 200 Traction AA Temperature A The following information relates to the system developed by the United States National Highway Traffic Safety Administration ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to Bat ...

© 2011-2025 Copyright www.ccruze.com